projects:3dprinting:anycubic_i3_mega
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:3dprinting:anycubic_i3_mega [2020/03/11 11:29] – admin | projects:3dprinting:anycubic_i3_mega [2020/11/09 01:16] (current) – [Antclaps BLTouch retrofit guide] admin | ||
---|---|---|---|
Line 2: | Line 2: | ||
This page lists modification guides for the ANYCUBIC I3 MEGA | This page lists modification guides for the ANYCUBIC I3 MEGA | ||
- | Wiring modification guide | + | ===== HUB PCB redesign and rewiring project ===== |
- | | + | | |
- | Antclaps BLTouch retrofit guide and configuration information: | + | * [[projects: |
- | * [[projects: | + | * [[projects: |
+ | ===== Antclaps BLTouch retrofit guide ===== | ||
+ | | [[projects:3dprinting: | ||
+ | * [[projects: | ||
+ | |||
+ | ===== Installing and adapting Guide for Marlin firmware ===== | ||
+ | | [[projects: | ||
* [[projects: | * [[projects: | ||
+ | |||
+ | ===== Cura BLTouch and Profile settings ===== | ||
+ | * [[projects: | ||
+ | |||
* [[projects: | * [[projects: | ||
+ | |||
+ | ===== Redrex extruder upgrade kit ===== | ||
* [[projects: | * [[projects: | ||
- | * [[projects: | ||
+ | ===== Anycubic I3 Mega with cable chain ===== | ||
+ | * [[projects: | ||
- | Temperature sensors | + | ===== Repairing the Trigorilla board: replacing ATMEGA2560 ===== |
- | * Heatbed: Arduino Pin 83 (Analog 14), with external pull-up of 4k7 | + | * [[projects: |
- | * Etc. | + |
projects/3dprinting/anycubic_i3_mega.1583922599.txt.gz · Last modified: 2020/03/11 11:29 by admin