Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:anycubic_i3_mega:cura_bltouch_and_profile_settings [2020/10/27 21:53] – [Cura Profile settings] admin
+++ projects:3dprinting:anycubic_i3_mega:cura_bltouch_and_profile_settings [2020/10/30 01:09] (current) – admin
@@ Line 9: / Line 9: @@
   - Cura settings -> Printer -> Manage printers\\ \\ {{:projects:3dprinting:001.machine_settings_manage_printers.png?563×164}}\\ \\
   - Machine Settings\\ \\ {{:projects:3dprinting:002.machine_settings.settings_button.png?563x246}}\\ \\
-  - Place "G29 - Automatic Bed Leveling" under the last G28\\ \\ {{:projects:3dprinting:004.Machine_settings_settings.png?563x571}}
+  - Place "G29 - Automatic Bed Leveling" under the last G28((To save time and machine wear, enter "M420 S1 ; use last-saved matrix for leveling". Obviously the leveling measurements must have been done before and stored with the M500 command after performing leveling.))\\ \\ {{:projects:3dprinting:004.Machine_settings_settings.png?563x571}}
 ==== 2. Initial feed for sticking layer ====
@@ Line 36: / Line 36: @@
 | ..//Top/Bottom Line Width//  | 0.40  | 0.35  | 0.35  |  mm  |
 | ..//Infill Line Width//  | 0.40  | 0.35  | 0.35  |  mm  |
-| Initial Layer Line Width  | 140  | 140  | 140  |  %  |
+| Initial Layer Line Width  | 140  | 200  | 200  |  %  |
 ^ Shell ^^^^^
 | Wall Thickness  | 1.2  | 1.2  | 1.2  |  mm  |
@@ Line 76: / Line 76: @@
 | ..Support Speed  | 30  | 30  | 30  |  mm/s  |
 | Travel Speed  | 50  | 50  | 50  |  mm/s  |
-| //Initial Layer Speed//  | 25.0  | 20.0  | 20.0  |  mm/s  |
+| //Initial Layer Speed//  | 25.0  | 10.0  | 10.0  |  mm/s  |
 | Skirt/Brim Speed  | 40  | 40  | 40  |  mm/s  |
 | Enable Acceleration Control  | ✔  | ✔  | ✔  | |

Auditeon

User Tools

Site Tools

Differences

Page Tools