Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb3 [2020/02/29 23:42] – admin
+++ projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb3 [2020/11/08 18:53] (current) – removed admin
@@ Line 1: / Line 1: @@
-====== Further redesign of the Mega Hub PCB (v3) ======
-Following up the changes from the [[projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb|second version]], further changes and simplifications were made. Most important were to leave out the 3 original red/blue/green connectors and only use D-sub connectors. Also a redundant X-stepper D-sub connection, one on the left and one on the right side, was made. This makes it possible to connect the stepper motor for the X-axis either from the left side (when using a dedicated cable chain), or from the right side (using the standard wiring).
-^  I3 MEGA HUB-III distribution circuit board  ^^
-|  {{ :projects:3dprinting:anycubic_i3_mega:i3_mega_hub_iii_top.png?400px |}}  |  {{ :projects:3dprinting:anycubic_i3_mega:i3_mega_hub_iii_bot.png?400px |}}  |
-|  //Top//  |  //Bottom//  |
-Following files are available of this project:
-  * {{ :projects:3dprinting:anycubic_i3_mega:i3_mega_hub3-schematics.pdf|ANYCUBIC I3 MEGA HUB-III schematic diagram}}
-  * {{ :projects:3dprinting:anycubic_i3_mega:i3_mega_hub3-outline.pdf|Circuit board outline (for modifying metal case}}
-  * {{ :projects:3dprinting:anycubic_i3_mega:i3_mega_hub3-pinout.pdf|Circuit board pinout description of all the connectors at the circuit board}}

Auditeon

User Tools

Site Tools

Differences

Page Tools