Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb [2020/11/16 23:48] – [Wiring the new circuit boards - externally] admin
+++ projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb [2022/07/12 13:31] (current) – [Wiring the new circuit boards - internally] admin
@@ Line 27: / Line 27: @@
 ===== Redesign of the Mega Hub PCB =====
-Within a period of one year, the circuit board evolved into the current design((The three earlier [[projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb_v1_v2_v3|iterations are described here]].
+Within a period of one year, the circuit board evolved into the current design((The three [[projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb_v1_v2_v3|predecessors are described here]].
 )) which has the following features:
   * ESD-protection on all pins which are connected to the controller.
@@ Line 40: / Line 40: @@
 The new circuit board fits at the original location. The breaking-off circuit board (using so-called mouse-bites) is meant to be located at the other side of the printer and provides connections for the X-stepper, Z-stepper-Left and accordingly endswitches.
+{{ :projects:3dprinting:anycubic_i3_mega:img_20201109_234033b.jpg?direct&400 |}}
 The reason that the original external dual row 2mm connectors were abandoned is that these are neither very robust, nor do they offer much flexibility in regard to upgrades/changes.
@@ Line 54: / Line 56: @@
 {{  :projects:3dprinting:anycubic_i3_mega:esd_principle2.png?direct&500  |}}
-The most important connection point for ground is realized using a REDCUBE PRESS-FIT T-Block, which has M4 thread and can be used to establish a connection with very low impedance. No (-) or ground wire shall be routed directly between the power supply and the controller circuit board. Instead, all these wires need first to go the T-Block and from there to the controller.
+The most important connection point for ground is realized using a [[https://www.we-online.com/katalog/datasheet/7461096.pdf|Würth REDCUBE PRESS-FIT T-Block]] (Art. Nr. 7461096), which has M4 thread and can be used to establish a connection with very low impedance. No negative or ground wire shall be routed directly between the power supply and the controller circuit board. Instead, all these wires need first to go the T-Block and from there to the controller.
-Internally the following cables need to be made:
-  * todo.
 ===== Wiring the new circuit boards - externally =====
 The following parts have been acquired. Supplier was Farnell:

Auditeon

User Tools

Site Tools

Differences

Page Tools