User Tools

Site Tools


projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb [2020/12/23 00:02] – [Redesign of the Mega Hub PCB] adminprojects:3dprinting:anycubic_i3_mega:redesign_hub_pcb [2022/07/12 13:31] (current) – [Wiring the new circuit boards - internally] admin
Line 41: Line 41:
 The new circuit board fits at the original location. The breaking-off circuit board (using so-called mouse-bites) is meant to be located at the other side of the printer and provides connections for the X-stepper, Z-stepper-Left and accordingly endswitches. The new circuit board fits at the original location. The breaking-off circuit board (using so-called mouse-bites) is meant to be located at the other side of the printer and provides connections for the X-stepper, Z-stepper-Left and accordingly endswitches.
  
 +{{ :projects:3dprinting:anycubic_i3_mega:img_20201109_234033b.jpg?direct&400 |}}
  
 The reason that the original external dual row 2mm connectors were abandoned is that these are neither very robust, nor do they offer much flexibility in regard to upgrades/changes. The reason that the original external dual row 2mm connectors were abandoned is that these are neither very robust, nor do they offer much flexibility in regard to upgrades/changes.
Line 56: Line 56:
 {{  :projects:3dprinting:anycubic_i3_mega:esd_principle2.png?direct&500  |}} {{  :projects:3dprinting:anycubic_i3_mega:esd_principle2.png?direct&500  |}}
  
-The most important connection point for ground is realized using a REDCUBE PRESS-FIT T-Block, which has M4 thread and can be used to establish a connection with very low impedance. No (-) or ground wire shall be routed directly between the power supply and the controller circuit board. Instead, all these wires need first to go the T-Block and from there to the controller. +The most important connection point for ground is realized using a [[https://www.we-online.com/katalog/datasheet/7461096.pdf|Würth REDCUBE PRESS-FIT T-Block]] (Art. Nr. 7461096), which has M4 thread and can be used to establish a connection with very low impedance. No negative or ground wire shall be routed directly between the power supply and the controller circuit board. Instead, all these wires need first to go the T-Block and from there to the controller.
- +
-Internally the following cables need to be made: +
-  * todo. +
 ===== Wiring the new circuit boards - externally ===== ===== Wiring the new circuit boards - externally =====
 The following parts have been acquired. Supplier was Farnell: The following parts have been acquired. Supplier was Farnell:
projects/3dprinting/anycubic_i3_mega/redesign_hub_pcb.1608678142.txt.gz · Last modified: 2020/12/23 00:02 by admin