projects:3dprinting:anycubic_i3_mega:upgrade_kit
This is an old revision of the document!
Redrex extruder upgrade kit
From the following page, an upgrade kit is offered, mainly containing a filament extruder motor with a gear reduction. The gear reduction would give the extruder more force to push the filament in.
The following information I was able to find:
- Increase the E-step value to 4001).
Extruder Frame Specifications:
- Material: Injection molding plastic
- Driving Gear Diameter: 12mm
- Driven Gear Diameter: 8mm
- Transmission Ratio: 3:1
- Stepper Motor Specifications:
- Motor Type: Bipolar Stepper
- Number of Phase: 2
- Step Angle: 1.8 deg.
- Rate Voltage: DC 3.0V
- Holding Torque:DC 1.2A
- Phase Resistance: 2.5ohms ±10%（20℃）
- Phase Inductance: 3.8mH ±20% (1KHz)
- Rotor Inertia: 30.8g.cm²
- Size: ±63*85*69mm
- Weight: ±290g
projects/3dprinting/anycubic_i3_mega/upgrade_kit.1583190402.txt.gz · Last modified: 2020/03/03 00:06 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
