projects:3dprinting:anycubic_i3_mega
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:3dprinting:anycubic_i3_mega [2019/12/12 01:02] – admin | projects:3dprinting:anycubic_i3_mega [2020/11/03 00:05] – admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Modifications for the ANYCUBIC I3 MEGA 3d printer ====== | ====== Modifications for the ANYCUBIC I3 MEGA 3d printer ====== | ||
- | This page lists modification guides for the ANYCUBIC I3 MEGA. Specifically, | + | This page lists modification guides for the ANYCUBIC I3 MEGA |
- | * [[projects: | + | |
- | * Reverse engineer the distribution circuit board in order swap the external connectors for dsub-types. | + | |
+ | ===== Wiring modification guide ===== | ||
+ | | [[projects: | ||
- | ===== Distribution circuit board ===== | + | ===== Antclaps BLTouch retrofit guide ===== |
- | The external connections of the 3d-printer are neither very robust, nor do they offer much flexibility in respect | + | Antclaps BLTouch retrofit guide and configuration information |
+ | * [[projects: | ||
+ | * [[projects: | ||
+ | * [[projects: | ||
+ | * [[projects: | ||
+ | * [[projects: | ||
- | The original circuit board was analyzed using a flatbed scanner: | + | * [[projects:3dprinting: |
- | ^ Anycubic I3 MEGA distribution circuit board (with and without annotation) ^^ | + | Further information |
- | | {{ : | + | * Heatbed temperature sensor: Atmega2560, Pin 83 (Analog 14), with external pull-up of 4k7 |
- | | {{ : | + | |
- | + | ||
- | Then with KiCad schematics were drawn and a new circuit board was designed: | + | |
- | + | ||
- | ^ I3 MEGA HUB-II distribution circuit board ^^ | + | |
- | | {{ : | + | |
- | | // | + | |
- | + | ||
- | The new circuit board consists of two parts, which can be separated with a so-called mouse-bite. The small circuit board is meant to be located at the other side of the printer. With this the wiring underneath the printer for the X-stepper and Z-stepper-L can be tidied up and organized much better. | + |
projects/3dprinting/anycubic_i3_mega.txt · Last modified: 2020/11/09 01:16 by admin