Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:anycubic_i3_mega [2020/11/09 01:14] – [Cura BLTouch and Profile settings] admin
+++ projects:3dprinting:anycubic_i3_mega [2020/11/09 01:16] (current) – [Antclaps BLTouch retrofit guide] admin
@@ Line 8: / Line 8: @@
   * [[projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb#redesign_of_the_mega_hub_pcb|Redesign of I3 MEGA HUB with ESD-protection and D-sub connectors.]]
 ===== Antclaps BLTouch retrofit guide =====
-|  [[projects:3dprinting:anycubic_i3_mega:redesign_hub_pcb|{{:projects:3dprinting:01.bltouch_mount_d.png?150}}]]  |
+|  [[projects:3dprinting:anycubic_i3_mega:bltouch_retrofit|{{:projects:3dprinting:01.bltouch_mount_d.png?150}}]]  |
   * [[projects:3dprinting:anycubic_i3_mega:bltouch_retrofit|Antclaps BLTouch retrofit guide and configuration information.]]
@@ Line 26: / Line 26: @@
   * [[projects:3dprinting:anycubic_i3_mega:cable_chain|Adding cable chains]]
-===== Replacing the ATMEGA2560 =====
+===== Repairing the Trigorilla board: replacing ATMEGA2560 =====
   * [[projects:3dprinting:anycubic_i3_mega:replacing_atmega2560|Replacing the ATMEGA2560]]
-Further information
-  * Heatbed temperature sensor: Atmega2560, Pin 83 (Analog 14), with external pull-up of 4k7
-  * Etc.

Auditeon