projects:mechanical:tests:heatpipes
This is an old revision of the document!
Table of Contents
Measuring heat-pipe quality
This page describes test procedures, measurements and results from comparing heat transfer capabilities between a certain type of heat-pipes.
Test method
 |  |  |
| Testing four heat-pipe | Clamp with transistor | Temperature measurement |
|---|
Results
| Compaq nx6110 nc6110 nx6120 nc6120 heat-pipe measurements |
|---|
 |
Analysis and results
- Heat-pipe #0 is defective. This can be seen in the graph. Further measurements at this heat-pipe had to be stopped to prevent damage to the transistor
- Heat-pipe #3 performs the best. At a room temperature of 22.1 °C, the final temperature when no further rise or fall can be detected is 35.9 °C. The dissipated power had been set to 18.5W
projects/mechanical/tests/heatpipes.1360804647.txt.gz · Last modified: 2013/02/14 02:17 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
