Differences

This shows you the differences between two versions of the page.

--- projects:repair:philips_pe1542_power_supply [2019/10/28 00:25] – admin
+++ projects:repair:philips_pe1542_power_supply [2019/10/28 00:26] – admin
@@ Line 24: / Line 24: @@
 Unfortunately, none of these parts are a direct replacement. Therefore some mechanical work is required to make these parts fit:
   * Mount the 6 potentiometers on an aluminium L-profile, Mount the whole assembly on the front panel with two spacers.
-  * Mount each switches behind the existing switch, by removing the original contacts. The cutting a square hole at the back of the original plastic handle. By shortening the handle of the new switch, at will fit into the old handle. Use a small test circuit board and some threaded rod and screws to mount the switch to the original metal casing.
+  * Mount each switch behind an existing switch, by removing the original contacts. The cutting a square hole at the back of the original plastic handle. By shortening the handle of the new switch, at will fit into the old handle. Use a small test circuit board and some threaded rod and screws to mount the switch to the original metal casing.
   * On the main PCB, increase the 6 holes for the potentiometers to 12mm. The new potentiometers are too short and must be soldered using additional wires, as can be seen on the last picture below.