software:programming:buspirate
This is an old revision of the document!
−Table of Contents
Bus pirate v4
Flashing with mplab_ipe
- use pickit3 to flash
- select PIC24FJ256GB106
- select hex file
- erase device
- program
- done
How to connect to arduino micro
wiring
* * * * * * * * * * * * * * * * *
(SWITCH)
USB PORT ARDUINO (2) (4) (6)
NANO
(1) (3) (5)
* * * * * * * * * * * * * * * * *
| BUSPIRATE | ARDUINO MICRO |
|---|---|
| MISO | MISO (1) |
| 5V | Vcc (2) |
| SCK | CLK (3) |
| MOSI | MOSI (4) |
| CS | RESET (5) |
| GND | GND (6) |
The Arduino micro can be powered directly from the buspirate. No external power is necessary.
avrdude command
$HOME/Backup/apps/arduino/arduino-1.8.13/hardware/tools/avr/bin/avrdude -C$HOME/Backup/apps/arduino/arduino-1.8.13/hardware/tools/avr/etc/avrdude.conf -v -patmega32u4 -c buspirate -P /dev/ttyACM3 -Uflash:w:/tmp/arduino_build_779360/stepper_motor_control.ino.hex:i
How to connect to arduino ATMEGA644
wiring
* * * * * * * * * * * * * * * * * *
ATMEGA644 (6) (5)
(4) (3)
(2) (1)
* * * * * * * * * * * * * * * * * *
| BUSPIRATE | ARDUINO ATMEGA644 |
|---|---|
| MISO | MISO (1) |
| 5V | Vcc (2) |
| SCK | CLK (3) |
| MOSI | MOSI (4) |
| CS | RESET (5) |
| GND | GND (6) |
The Arduino ATMEGA644 can be powered directly from the buspirate. No external power is necessary.
software/programming/buspirate.1610537398.txt.gz · Last modified: 2021/01/13 12:29 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
