software:psion:hardware_info
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Previous revision | |||
— | software:psion:hardware_info [2008/05/14 17:54] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Hardware Info ====== | ||
+ | This page describes how to take the NBP appart upgrade the motherboard. (Don't know if the normal NBP can be upgraded) | ||
+ | ===== How to take your netbook pro to bits ===== | ||
+ | * First remember to unplug all the hardware - MMC, CF, PCMCIA, stylus, both sorts of battery, power, serial, usb connectors. Make sure the PCMCIA lever is pushed back in. Same for CF button. | ||
+ | * Open the lid and peel the left hand edge of the 'Psion Teklogix' | ||
+ | * Undo the screw that is revealed. | ||
+ | * Take off the battery cover and the similar cover to the right. | ||
+ | * Pull out the front hinge pins - one either side. They just slide out in the inboard direction. The display will flop back when you do this. | ||
+ | * Now you can lift off the top plastic cover. There is another loose bit of plastic underneath around the battery compartment. | ||
+ | * Undo the screw at the top right of the keyboard. | ||
+ | * Release the keyboard connector (little plastic ears slide back). | ||
+ | * Remove the keyboard - another bit of plastic comes off (from LHS). | ||
+ | * Take off 2 screws and the display cable clamp. | ||
+ | * Release the display cable (plastic clamp flips up). | ||
+ | * Remove screw on bottom RHS to release RHS of keyboard bit of plastic. | ||
+ | * Remove 5 large motherboard screws. Lift off the grey plastic lever in the back LH corner (Nicad fitted sensor). | ||
+ | * The PCB can now be gently withdrawn upwards/ | ||
+ | Assembly is "the reverse of diassaembly", | ||
+ | |||
+ | ===== Powering up ===== | ||
+ | Now give it some power but no CF and put in a dongle/ | ||
+ | |||
+ | To recalibrate type touch i auto and then prod the 4 crosses. Now you can scribble on the blank screen to check (a yellow line is drawn). Now type w < | ||
+ | |||
+ | Then reboot and use. |
software/psion/hardware_info.txt · Last modified: 2008/05/14 17:54 by 127.0.0.1