Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:anycubic_i3_mega:bltouch_retrofit [2020/03/08 21:39] – admin
+++ projects:3dprinting:anycubic_i3_mega:bltouch_retrofit [2020/07/02 12:14] (current) – [Hardware changes] admin
@@ Line 10: / Line 10: @@
   * D11 (Mega 2560, digital pin 11) for the control signal
-To understand how to connect the leveller to the controller, the following overview shows how the signals are routed (click on pictures for larger size):
+To understand how to connect the leveller to the controller, the following overview((The original version of this drawing showed a wrong path for the entry point of the D2 wire (large connector instead of middle connector, pin 5) at the I3-MEGA-HUB circuit board, and the continuation of this wire at the HUB circuit board (green wire, not yellow), as was pointed out on 02-07-2020 by Mr. Marco Burato. Current drawings show the correct routing.)) shows how the signals are routed (click on pictures for larger size):
 ^  Anycubic I3 MEGA BLTouch wiring overview  ^^
 |  {{:projects:3dprinting:schematic_drawing_ext.png?direct&291|External wiring}}  |  {{:projects:3dprinting:schematic_drawing_int.png?direct&360|Internal wiring}}  |