projects:mechanical:tests:heatpipes
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| projects:mechanical:tests:heatpipes [2013/02/14 02:24] – [Conclusion] admin | projects:mechanical:tests:heatpipes [2019/09/22 11:03] (current) – admin | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Measuring heat-pipe quality ====== | ====== Measuring heat-pipe quality ====== | ||
| - | This page describes test procedures, measurements and results from comparing heat transfer capabilities between a certain type of heat-pipes.\\ | + | This page describes test procedures, measurements and results from comparing heat transfer capabilities between a certain type of heat-pipes |
| ==== Test method ==== | ==== Test method ==== | ||
| - | | {{ http:// | + | * As heat source a TIP42C PNP-transistor was used with a 56Ω resistor between the basis and the collector. During testing the maximum emitter-base voltage was measured and well below the maximum of 5v.\\ During heat dissipation, |
| - | ^ Testing four heat-pipe | + | * The fan which Compaq used in the laptop was used and ran at maximum speed, at 5v. With sticky tape all air was forced to flow through the narrow radiator channel. |
| + | * The ambient temperature was 22.1°C. | ||
| + | * After powering up fan and transistor, every 5 seconds a temperature reading was recorded from the temperature sensor. After 120 seconds the temperature would not vary very much and instead of recording every 5 seconds, 4 minutes had been waited and the final temperature had been read. At this moment all of the heat-pipes (Except #0) were in a thermal equilibrium. | ||
| + | |||
| + | | {{ https:// | ||
| + | ^ Testing four heat-pipes | ||
| ==== Results ==== | ==== Results ==== | ||
| ^ Compaq nx6110 nc6110 nx6120 nc6120 heat-pipe measurements | ^ Compaq nx6110 nc6110 nx6120 nc6120 heat-pipe measurements | ||
| - | | {{ http:// | + | | {{ https:// |
| ==== Conclusion ==== | ==== Conclusion ==== | ||
| - | * Heat-pipe #0 is clearly broken. Because the heat-pipe is not transferring any heat away, the temperature | + | * Heat-pipe #0 is clearly broken. Because |
| - | * Heat-pipe #3 performs the best. At a room temperature of 22.1 °C, the final temperature when no further rise or fall can be detected is 35.9 °C. The dissipated power had been set to 18.5W | + | * The largest differences were to be found between heat-pipe 1 and 3. At thermal equilibrium the temperature difference was about 4.5 °C. |
| + | * Heat-pipe #3 performs the best. At a room temperature of 22.1 °C, the final temperature when no further rise or fall can be detected is 35.9 °C. The dissipated power had been set to 18.5W. | ||
projects/mechanical/tests/heatpipes.1360805045.txt.gz · Last modified: 2013/02/14 02:24 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
