projects:3dprinting:anycubic_i3_mega
This is an old revision of the document!
Table of Contents
Modifications for the ANYCUBIC I3 MEGA 3d printer
This page lists modification guides for the ANYCUBIC I3 MEGA
Wiring modification guide
 |
Antclaps BLTouch retrofit guide
Installing and adapting Guide for Marlin firmware
Cura BLTouch and Profile settings
Redrex extruder upgrade kit
Anycubic I3 Mega with cable chain
Replacing the ATMEGA2560
Further information
- Heatbed temperature sensor: Atmega2560, Pin 83 (Analog 14), with external pull-up of 4k7
- Etc.
projects/3dprinting/anycubic_i3_mega.1604859387.txt.gz · Last modified: 2020/11/08 19:16 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
